Rockwell Automation 1395 Digital DC Drive FRN 5-10.10/9.30 - Manual (Page 16)

Chapter 1
Introduction, Inspection & Storage, and
Publication References
1-6
Digital Reference In-
put (1) –
Digital Inputs (10) –
Discrete Outputs (5) –
Analog Inputs (2) –
Analog Outputs (2) –
Current source and sink input for high
common mode noise immunity. Nominal
5VDC or 12VDC interface (internal hard-
ware configurable), + 10mA nominal cur-
rent source/sink requirements.
24VDC Nominal; 18VDC minimum,
28VDC maximum; 10 mA nominal.
Digital Reference
Board;
Power Supply –
(for external use)
-25%, +16.6%, 24VDC nominal; Current
sourcing type driver; Diode clamped for
inductive load; 18VDC minimum,
28VDC maximum; 1.5VDC saturation,
100mA maximum load.
0 to +/– 10 VDC, differential input imped-
ance– differential > 1m ohm; 20K ohms
(single ended to analog common).
–10 to +10VDC, 2.5mA maximum output
impedance – 200 ohms.
+10VDC, 4mA maximum, –10VDC, 4mA
maximum.
This board allows the Bulletin 1395 to be
controlled using an Allen-Bradley PLC
controller from either the PLC3 or PLC5
family. The +5V Node Adapter board
power is generated internally in the Drive.
Multi-Communications
Adapter Board;
Node Adapter Board;
Power Supply –
Communications
Channels (2) –
Function Blocks (4)
Discrete Input (1)
Board power provided by Drive discrete
input, 24VDC or 115VAC, jumper select-
able.
Each channel can be configured as either
Allen-Bradley Remote I/O (RIO) or
Allen-Bradley Data Highway + (DH+) in-
terfaces.
Compatible with PLC3, PLC250,
PLC5/15, PLC5/25, PLC5/40, PLC5/60
and Controlview.
These programmable function blocks can
be used to manipulate data.
One programmable discrete input is avail-
able (24VDC or 115VAC).