Rockwell Automation 1203-EN1 EtherNet/IP-to-SCANport Module - Manual (Page 106)

B-6 Module Parameters
36
37
38
39
40
41
42
43 [Flt Cfg A1 In]
[Flt Cfg A2 In]
[Flt Cfg B1 In]
[Flt Cfg B2 In]
[Flt Cfg C1 In]
[Flt Cfg C2 In]
[Flt Cfg D1 In]
[Flt Cfg D2 In]
Sets the data that is sent to the Datalink in the
drive if any of the following is true:
• Parameter 30 - [Comm Flt Action] is set to
“Send Flt Cfg” and communications are
disrupted.
• Parameter 31 - [Idle Flt Action] is set to “Send
Flt Cfg” and the scanner is idle.
• Parameter 51 - [Peer Flt Action] is set to “Send
Flt Cfg” and communications are disrupted.
Default: 0
Default: 0
Default: 0
Default: 0
Default: 0
Default: 0
Default: 0
Default: 0
Minimum: 0
Maximum: 65535
Type: Read/Write
Reset Required: No
44 [Serial Port Rate]
Sets the data rate of the serial port. Default: 2 = 9600 bps
Values: 0 = 2400 bps
1 = 4800 bps
2 = 9600 bps
3 = 19.2 Kbps
4 = 38.4 Kbps
Type: Read/Write
Reset Required: Yes
45 [M-S Input]
Sets the Master-Slave input data. This data is
produced by the scanner and consumed by the
module. Default: xxx0 0001
Bit Values: 0 = I/O disabled
1 = I/O enabled
Type: Read/Write
Reset Required: Yes
Bit Definitions
0 = Cmd/Ref
1 = Datalink A Input
2 = Datalink B Input
3 = Datalink C Input
4 = Datalink D Input
5 = Not Used
6 = Not Used
7 = Not Used
Parameter
No. Name and Description
Details
Bit
Default 1 0 0 0 0 x x x
0 1 2 3 4 5 7 6