Rockwell Automation 1203-EN1 EtherNet/IP-to-SCANport Module - Manual (Page 86)

7-6 Troubleshooting
The module maintains an event queue that reports the history of its
actions. You can view the event queue using DriveExplorer (4.03 or
higher) or DriveExecutive (3.01 or higher) software.
Events
Many events in the Event queue occur under normal operation. If you
encounter unexpected communications problems, the events may help
you or Allen-Bradley personnel troubleshoot the problem. The following
events may appear in the event queue:
Viewing and Clearing Events
Code Event Description
1 No Event Empty event queue entry.
2 SCANport
Bus Off Flt A bus-off condition was detected on SCANport. This event may
be caused by loose or broken cables or by noise.
3 Ping Time Flt A ping message was not received on SCANport within the
specified time.
4 Port ID Flt The module is not connected to a correct port on a SCANport
product.
5 Port Change
Flt The SCANport port changed.
6 Host Sent
Reset The drive sent a reset event message.
7 EEPROM
Sum Flt The EEPROM in the module is corrupt.
8 Online @
125kbps The module detected that the drive is communicating at 125
kbps.
9 Reserved Not used.
10 Bad Host Flt The module was connected to an incompatible product.
11 Reserved Not used.
12 Type 2 Login The module has logged in for type 2 control.
13 Type 2 Time
Flt The module has not received a type 2 status message within the
specified time.
14 DL Login The module has logged into a Datalink.
15 DL Reject Flt The drive rejected an attempt to log in to a Datalink because the
Datalink is not supported or is used by another peripheral.
16 DL Time Flt The module has not received a Datalink message within the
specified time.
17 Reserved Not used.
18 Reserved Not used.
19 Reserved Not used.
20 Reserved Not used.
21 Reserved Not used.
22 App Updated Startup sequence detected new application firmware.