Rockwell Automation 1203-EN1 EtherNet/IP-to-SCANport Module - Manual (Page 22)

2-4 Installing the Module
Panel Mounting Procedure Using Module as a Template
The following procedure enables you to use the assembled module as a
template for drilling holes in the panel.
1. Using the assembled module as a template, carefully mark the center
of both holes on the panel.
2. Remove the module to a clean location.
3. Drill and tap the mounting holes for the recommended M4 or #8
panhead screws (supplied separately).
4. Place the module back on the panel, and check for proper hole
alignment.
5. Attach the module to the panel using the mounting screws.
DIN Rail Mounting
The module can be mounted using the following DIN rails:
• 35 x 7.5 mm (EN 50 022 - 35 x 7.5)
• 35 x 15 mm (EN 50 022 - 35 x 15)
Before mounting the module on a DIN rail, open the DIN rail latch.
Press the DIN rail mounting area of the module against the DIN rail, and
manually lock the DIN rail latch (
Figure 2.3 ).
Figure 2.3 DIN Rail Mounting