Rockwell Automation 1203-EN1 EtherNet/IP-to-SCANport Module - Manual (Page 46)

4-2 Configuring the Scanner or Bridge
To establish communications over an EtherNet/IP network, you must
first add the controller and its scanner or bridge to the I/O configuration.
1. Start RSLogix 5000. The RSLogix 5000 window appears.
Figure 4.2 RSLogix 5000 Window
2. In the Control Organizer pane, right-click the I/O Configuration
folder and select New Module ( Figure 4.2 ). The Select Module Type
dialog box ( Figure 4.3 ) appears.
Figure 4.3 Select Module Type Dialog Box
Adding a Bridge or Scanner to the I/O Configuration
➌
➌
➍