Rockwell Automation 1203-EN1 EtherNet/IP-to-SCANport Module User Manual
Page 48
Advertising
4-4
Configuring the Scanner or Bridge
To transmit data between the scanner or bridge and the module, you must
add the 1203-EN1 module as a child device of the scanner or bridge.
1. In the Control Organizer pane, right-click on the scanner or bridge
and select New Module (
). In our example, we right-click
on the 1756-ENBT/B bridge.
Figure 4.6 Right-Clicking on the Scanner
The Select Module Type dialog box (
Figure 4.7 Select Module Type Dialog Box
2. Select ETHERNET-MODULE (
) to configure a
1203-EN1, and then click OK.
The Module Properties dialog box (
Adding the Module and Drive to the I/O Configuration
Advertising