Chapter 2, Installing the module, Preparing for an installation – Rockwell Automation 1203-EN1 EtherNet/IP-to-SCANport Module User Manual
Page 19: Setting the, 2installing the module, Chapter
Chapter
2
Installing the Module
Chapter 2 provides instructions for installing the module.
Before installing the EtherNet/IP-to-SCANport module:
• Read the EtherNet/IP Performance and Application Guide,
Publication ENET-AP001…, and EtherNet/IP Media Planning and
Installation Manual, Publication ENET-IN001….
• Verify that you have all required equipment. Refer to
Important: To guard against device malfunction, use a grounding wrist
strap when installing the EtherNet/IP module.
To use the module web pages, the Web Pages Switch must be set to its
“Enable Web” position.
Important: A new setting is recognized only when power is applied to
the module, or the module is reset. If you change a setting,
cycle power or reset the module.
Topic
Page
Connecting the Module to the Network and Drive
Preparing for an Installation
Setting the Web Pages Switch