Rockwell Automation 1203-EN1 EtherNet/IP-to-SCANport Module - Manual (Page 47)

Configuring the Scanner or Bridge 4-3
3. In the list, select the EtherNet/IP scanner or bridge used by your
controller and then select the major revision of its firmware in the
Major Revision box. In this example (
Figure 4.3 ), we use a
1756-ENBT EtherNet/IP Bridge (Series B), so the 1756-ENBT/B
option is selected.
4. Click OK. The Module Properties dialog box ( Figure 4.4 ) appears.
Figure 4.4 Module Properties Dialog Box - Page 1
5. Edit the following:
6. Click Finish>>. The scanner or bridge is now configured for the
EtherNet/IP network. It appears in the I/O Configuration folder. In
our example, a 1756-ENBT bridge appears under the I/O
Configuration folder (
Figure 4.5 ).
Figure 4.5 RSLogix 5000: I/O Configuration Folder
Box Type
Name A name to identify the scanner or bridge.
Slot The slot of the EtherNet/IP scanner or bridge in the rack.
Revision The minor revision of the firmware in the scanner. (You
already set the major revision in the Select Module Type
dialog box,
Figure 4.3 .)
IP Address The IP address of the EtherNet/IP scanner or bridge.
Electronic Keying Compatible Module. This setting for Electronic Keying
ensures the physical module is consistent with the software
configuration before the controller and scanner or bridge
make a connection. Therefore, ensure that you have set the
correct revision in this dialog box. Refer to the online Help if
the controller and scanner have problems making a
connection and you want to change this setting.