Rockwell Automation 1203-EN1 EtherNet/IP-to-SCANport Module - Manual (Page 23)

Installing the Module 2-5
1. Remove power from the drive.
2. Connect an Ethernet cable to the EtherNet/IP network. See
Figure 2.4 for an example of wiring to an EtherNet/IP network.
3. Route the Ethernet cable to the module, and insert the cable’s plug
into the mating module receptacle.
4. Connect a 1202-Cxx Communication Cable to the mating connector
on the module, and then to the port on the drive.
Figure 2.4 Connecting the Ethernet Cable to the Network
Connecting the Module to the Network and Drive
!
ATTENTION: Risk of injury or death exists. The drive may contain
high voltages that can cause injury or death. Remove power from the
drive, and then verify power has been discharged before installing or
removing an module.
!
ATTENTION: Risk of equipment damage, injury or death exists.
Unpredictable operation may occur if you fail to verify that parameter
settings are compatible with your application. Verify that settings are
compatible with your application before applying power to the drive.
JOG
ESC SEL
Switch
ControlLogix with
EtherNet/IP Bridge 1305 Drive
Router
(optional)
Ethernet Cable 1202-Cxx
Communication
Cable
1203-EN1
EtherNet/IP
Module