Rockwell Automation 1203-EN1 EtherNet/IP-to-SCANport Module - Manual (Page 17)

Getting Started 1-5
This section is provided to help experienced users quickly start using the
EtherNet/IP module. If you are unsure how to complete a step, refer to
the referenced chapter.
Quick Start
Step Refer to . . .
1 Review the safety precautions for the module. Throughout This
Manual
2 Verify that the drive is properly installed. Drive User Manual
3 Install the module.
Panel or DIN rail mount the module. Verify that the drive is not
powered. Then, connect the module to the network using an
Ethernet cable and to the drive using a 1202 communications
cable (1202-Cxx).
Chapter 2 ,
Installing the
Module
4 Apply power to the module (and drive).
The module requires DC power, either from a DC power
source or from an AC/DC converter. Apply power to the
module. Then apply power to the drive. The status indicators
should be green. If they flash red, there is a problem. Refer to
Chapter 7 , Troubleshooting .
Chapter 2 ,
Installing the
Module
5 Configure the module for your application.
Set the parameters for the following module features as
required by your application:
• IP address, subnet mask, and gateway address
• EtherNet/IP data rate
• I/O configuration
• Master-Slave or Peer-to-Peer hierarchy
• Fault actions
Chapter 3 ,
Configuring the
Module
6 Configure the scanner or bridge to communicate with the
module.
Use a software tool such as RSLogix 5000 to configure the
master on the EtherNet/IP network to recognize the module
and drive. Chapter 4 ,
Configuring the
Scanner or Bridge
7 Create a ladder logic program.
Use a programming tool such as RSLogix to create a ladder
logic program that enables you to:
• Control the module and connected drive using I/O.
• Monitor or configure the drive using Explicit messages.
Chapter 5 ,
Using I/O
Messaging
Chapter 6 ,
Using Explicit
Messaging