Configuring a station on a point-to-point link, Configuring a station on a point-to-point link -33 – Rockwell Automation DAG6.5.8 APPLICATION GUIDE SCADA SYSTEM User Manual
Page 101
Advertising
Publication AG-UM008C-EN-P - February 2005
Configuring MicroLogix 1100/1200/1500 Controllers 3-33
Configuring a Station on a
Point-to-Point Link
To configure the processor for point-to-point communication, follow
the steps below using your programming software:
Use Worksheet 3.4 MicroLogix 1100/1200/1500 DF1 Full-Duplex
Point-to-Point Configuration (page D-12) for an example configuration
and to record your station’s configuration.
1. To bring up the Channel
Configuration interface,
double-click on the Channel
Configuration icon.
2. On the Channel tab, choose
DF1 Full-Duplex for your
Driver.
3. Configure the communication
driver characteristics
according to Table 3.9.
Advertising