Rockwell Automation DAG6.5.8 APPLICATION GUIDE SCADA SYSTEM - Manual (Page 331)

1 Publication AG-UM008C-EN-P - February 2005
Chapter
11
Remotely Program Allen-Bradley Processors
Over a Telemetry Network
Chapter Objectives This chapter helps you set up and configure RSLogix programming
terminals on Ethernet to program remote PLC-5, SLC 500, MicroLogix,
and Logix processors over a point-to-multipoint telemetry network.
Connecting RSLogix programming software to the remote stations
over the telemetry network helps you do the following without having
to go to the remote site:
•
monitor the online data table
•
upload, download, and edit the ladder logic program
•
troubleshoot the system
You can remotely connect to your processors while normal telemetry
system data acquisition and control functions occur concurrently.
For information about See page
remote programming via RSLinx Classic Gateway 11-2
remote programming via SLC 5/05 Ethernet to DF1 Passthru 11-4
remote programming via Logix Ethernet/IP to DF1 Bridge 11-7