Rockwell Automation DAG6.5.8 APPLICATION GUIDE SCADA SYSTEM - Manual (Page 160)

Publication AG-UM008C-EN-P - February 2005
4-22 Configuring SLC 5/03, 5/04, and 5/05 Processors
Configuring a Slave Station To choose the processor as a slave station, follow the steps below
using your programming software:
1. To bring up the Channel
Configuration interface,
double-click on the Channel
Configuration icon.
2. Define the location of the
diagnostic file used for
Channel Status here. For
Channel Status details, see
page 4-25.
3. On the Channel 0 tab, choose
DF1 Half-Duplex Slave for
your Driver.
4. Configure the communication
driver characteristics
according to Table 4.5.