Rockwell Automation DAG6.5.8 APPLICATION GUIDE SCADA SYSTEM - Manual (Page 17)

Publication AG-UM008C-EN-P - February 2005
Preface 3
Terms We use these terms frequently in this book:
See the Glossary for other definitions.
Address Conventions Addresses
Term Definition
Logix processor A collective name used to refer to ControlLogix™,
FlexLogix™, and CompactLogix™ processors.
Enhanced PLC-5 processor A collective name used to refer to PLC-5/11, -5/20,
-5/30, -5/40, -5/60, and PLC-5/80 processors.
Ethernet PLC-5 processor A collective name used to refer to PLC-5/20E,
-5/40E, and -5/80E processors.
master station A device (programmable controller with I/O modules
or a workstation) that sends data to and collects
data from devices connected on a
point-to-multipoint, half-duplex network.
slave station A device (programmable controller with I/O modules)
that is located in a remote site away from the master
station and that controls I/O points at the remote
site. A slave station accepts commands from and
can send data (if capable) to a master station via a
telemetry network.
These values Are represented as
octal X
8
decimal X
10