Overview, Overview -2 – Rockwell Automation DAG6.5.8 APPLICATION GUIDE SCADA SYSTEM User Manual
Page 206
Advertising
Publication AG-UM008C-EN-P - February 2005
6-2 Configuring MicroLogix 1000 Controllers
Overview
To configure a MicroLogix 1000 controller:
1. Connect the serial cable to the PC.
The controller must be online to configure DF1 half-duplex
slave parameters.
2. Define the controller’s communication characteristics using
RSLogix 500 programming software.
3. Disconnect the controller from the programming PC and install
the controller at its working destination.
4. Connect the modem to the controller’s serial channel.
Figure 6.1 Basic Configuration
RSLogix 500
programming
software
modem
Advertising