Configuring the controller as a slave station, Configuring the controller as a slave station -19 – Rockwell Automation DAG6.5.8 APPLICATION GUIDE SCADA SYSTEM User Manual
Page 245
Advertising
Publication AG-UM008C-EN-P - February 2005
Configuring Logix Controllers 7-19
Configuring the Controller
as a Slave Station
To configure the controller as a slave station, follow the steps below
using your programming software:
Use Table 7.6 to help you understand the communication parameters
you need to specify on the Controller Properties screen.
Use Worksheet 7.3 (page D-24) for an example configuration and to
record your station’s configuration.
1. To bring up the Controller Properties
interface, click on the controller icon
just beneath the keyswitch icon.
2. Choose the Serial Port Protocol tab
and configure according to your
specification. Serial Port Protocol
parameters and defaults can be
found in Table 7.6.
Advertising