Configuring a point-to-point station, Configuring a point-to-point station -13 – Rockwell Automation DAG6.5.8 APPLICATION GUIDE SCADA SYSTEM User Manual
Page 217
Advertising
Publication AG-UM008C-EN-P - February 2005
Configuring MicroLogix 1000 Controllers 6-13
Configuring a
Point-to-Point Station
To choose the controller as a point-to-point station, follow the steps
below using your programming software:
1. Double-click on the Channel
Configuration icon to bring up
the Channel Configuration
interface.
2. Scroll down the list and
choose the desired baud rate.
3. Click the radio button and
choose Full Duplex.
4. Communication
characteristics are not
adjustable in Full Duplex. See
table 6.2 for default parameter
settings.
Advertising