Baseline Systems BaseStation 1000 - Manual (Page 35)

BaseStation 1000 Irrigation Controller Manual
7. Press the  or  button to move through the list. Highlight the MV/Pump number that you
want to assign the device to.
8. Press the OK button to select the MV/Pump
number. The serial number of the device that
you selected in the Action column now
displays next to the number in the MV/Pump
column.
Note: If the search found multiple devices,
the next serial number in the Action column
is automatically selected. Press the  or 
button in the MV/Pump column to move to the next number that you want to assign, and
then press the OK button.
9. Continue until you have assigned all your MV/pump start biCoders to their numbers.
Setting Up Master Valves/Pumps
After you assign a device to a specific use in the BaseStation 1000 system, the device is
automatically enabled. You can disable that device if you want to take it out of service temporarily,
and then you can enable it again when necessary.
1. Press the Search & Assign button. The Search & Assign menu displays.
2. Press the  or  button to highlight the MV/Pump option, and then press the OK button to
select it. The MV/Pump screen displays.
3. Press the  or  button to highlight the Device Setup option, and then press the OK button.
The MV/Pump Device Setup screen displays.
4. Press the  or  button to highlight the MV/Pump number in the left column, and then press
the  button to move to the Enabled field.
 If the device is currently enabled, a checkmark displays in the Enabled field. Press the +
or – button to remove the checkmark.
 If the device is currently disabled, there is no checkmark in the Enabled field. Press the
+ or – button to replace the checkmark.
5. Press the  button to move to the Normally Open field. If you want this device to allow
water in the pipes at all times, press the OK button to put a checkmark in this field. If you
want to configure the device as Normally Closed, leave the field blank.
6. Press the  button to move to the Drive Level field. Press the OK button to read the current
drive level of the device.
7. When the number displays in the Drive Level field, press the + or – button to change the
setting. You can enter a number between 1 and 3.
8. Continue until you have configured the settings for all your master valve and pump devices.
Page 29