Baseline Systems BaseStation 1000 - Manual (Page 38)

BaseStation 1000 Irrigation Controller Manual
1. Press the Search & Assign button. The Search & Assign menu displays.
2. Press the  or  button to highlight the Flow Sensor option, and then press the OK button to
select it. The Flow Sensor screen displays.
3. Press the  or  button to highlight the Device Setup option, and then press the OK button.
The Flow Device Setup screen displays.
4. Press the  or  button to highlight the flow device number in the left column, and then
press the  button to move to the Enabled field.
 If the device is currently enabled, a checkmark displays in the Enabled field. Press the +
or – button to remove the checkmark.
 If the device is currently disabled, there is no checkmark in the Enabled field. Press the
+ or – button to replace the checkmark.
5. Press the  button to move to the K-Value field.
Note: The K-Value is a calibration factor for a flow device expressed in pulses per unit volume.
The K-Value is used to calibrate the volumetric throughput of a flow device. Manufacturers
give the K-Value (or K-Factor) of their flow device in the device specification.
 If the device is a Baseline flow biCoder, the correct K-Value automatically displays in the
field. Press the + or – button to change the K-Value if necessary.
 If the device is not a Baseline flow biCoder, you need to enter the K-Value manually.
Find the K-Value for the device in the manufacturer’s documentation, and then press
the + or – button to enter the number in the K-Value field.
6. Continue until you have configured the settings for all your flow devices.
Searching For and Assigning Event Switch Devices
1. Press the Search & Assign button. The Search & Assign menu displays.
2. Press the  or  button to highlight the Event Switch option, and then press the OK button
to select it. The Event Switch screen displays.
3. If the Device Assignment option is highlighted, press the OK button to select it. If Device
Assignment is not highlighted, press the  or  button to highlight it, and then press the OK
button. The E. Switch Assignment screen displays.
4. When the Search option in the Action column is highlighted, press the OK button to search
for switch devices.
When the controller finds the devices, their serial numbers display in the Action column.
5. Press the  or  button to move through the list of devices in the Action column. Highlight
the serial number of the switch device that you want to assign.
6. Press the  button to move to the Event Switch column.
7. Press the  or  button to move through the list. Highlight the number that you want to
assign the switch device to.
Page 32