Baseline Systems BaseStation 1000 - Manual (Page 76)

BaseStation 1000 Irrigation Controller Manual
Manually Running Master Valves/Pumps
1. Press the Manual Run button. The Manual Run menu displays.
2. Press the  or  button to highlight Run MVs/Pumps, and then press the OK button. The
Run MVs/Pumps screen displays.
3. Notice that the minutes placeholder in the
Runtime field is highlighted.
 To move to the seconds placeholder,
press the  button.
 To move to the hour placeholder, press
the  button.
 To change the time, press the + or –
button.
Note: To rapidly increase or decrease the value, press and hold the + button or the –
button.
4. Press the  button to highlight the fields for the MV/Pumps that you want to run, and then
press the + button to select the devices.
5. To start the manual run, press the RUN button.
Manually Starting or Stopping a Program
1. Press the Manual Run button. The Manual Run menu displays.
2. Press the  or  button to highlight Start/Stop Program, and then press the OK button. The
Start/Stop Program screen displays.
3. In the list of programs, press the  or  button to move to the program that you want to
start or stop.
 If the program is idle, the Start? option
displays on the right side of the screen.
To start the program, highlight the
Start? option, and then press the OK
button. The label to the right of the
program number changes to “Running.”
 If the program is running, the Stop?
option displays on the right side of the
screen. To stop the program, highlight the Stop? option, and then press the OK button.
The label to the right of the program number changes to “Done.”
Note: To check the status of the program, press the RUN button, and then press the BACK
button. On the Status menu, press the  button to move to the Program Status option, and
then press the OK button. The Program Status screen display. Refer to Viewing the Program
Status Report on page 90.
Page 70