Baseline Systems BaseStation 1000 - Manual (Page 74)

BaseStation 1000 Irrigation Controller Manual
7. Press the  button to highlight the Set Manual Runtimes option, and then press the OK
button. The Run Prg Zone(s) screen displays.
8. Notice that the minutes placeholder in the
Zone 1 field is highlighted.
 To move to the hour placeholder, press
the  button.
 To move to the seconds placeholder,
press the  button.
 To change the time, press the + or – button.
Note: To rapidly increase or decrease the value, press and hold the + button or the –
button.
 To move to a different zone, press the  or  button.
9. After you have set the amount of time for each zone that you want to run manually, press the
OK button. The Manual Run screen displays the elapsed time.
10. When the manual run is complete, the message screen displays “No Running Zones.” Choose
one of the following options:
 If you want to start another manual run with the same runtimes, press the Manual Run
button. Select the Run Prg Zone(s) option and then the Set Manual Runtimes option.
The runtimes that you entered in the fields on the Run Prg Zone(s) screen are saved.
Press the OK button to start the manual run.
 If you want to start another manual run with different runtimes, press the Manual Run
button. Select the Run Prg Zone(s) option, and then select the Clear Manual Runtimes
option. The system automatically clears all the runtimes that you entered in the fields
on the Run Zone(s) screen. Select the Set Manual Runtimes option, enter the new
runtimes, and then press the OK button to start the manual run.
 If you want to display the Zone Status, press the BACK button. Press the  or  button
to highlight Zone Status, and then press the OK button.
Manually Running All Zones in a Program
In the BaseStation 1000, you can manually run all zones by program. You can set the manual
runtime between 1 second and 18 hours.
1. Press the Manual Run button. The Manual Run menu displays.
2. Press the  or  button to highlight Run All Prg Zones, and then press the OK button. The
Run All Prg Zones screen displays.
3. If the program that you want to run zones for displays in the upper-left corner of the screen,
continue to step 3. Otherwise, press the PRG button until the program that you want displays
in the upper-left corner of the screen.
Note: To move backwards in the list of programs, press and hold the PRG button, and then
press the – button repeatedly.
Page 68