Baseline Systems BaseStation 1000 - Manual (Page 55)

BaseStation 1000 Irrigation Controller Manual
Setting the Number of Zones that Can Run at One Time
Depending on the amount of water available from your water source and the electrical limits, your
system might be able to operate more than one zone at a time. You can configure the BaseStation
1000 for a maximum number of zones that can run at one time for each program. You can also
configure the maximum number of zones that can run at one time for all programs.
1. Press the Program Setup button. The Program Setup menu displays.
2. If the program that you want to modify displays in the upper-left corner of the screen,
continue to step 3. Otherwise, press the PRG button until the program that you want to
modify displays in the upper-left corner of the screen.
Note: To move backwards in the list of programs, press and hold the PRG button, and then
press the – button repeatedly.
3. Press the  or  button to highlight the
Zones at One Time option, and then press
the OK button. The Zones at One Time
screen displays.
4. Press the + or – button to change the
number in the Max Concurrent field to
indicate the maximum number of zones
that can run at the same time in this
program.
5. Press the  or  button to move to the Max All Programs field.
6. Press the + or – button to change the number in the Max All Programs field to indicate the
maximum number of zones that can run at the same time when more than one program is
running at once.
7. Press the RUN button to exit Program Setup.
Enabling or Disabling Programs
By default, all BaseStation 1000 programs are enabled, which means that those programs will run
when devices are connected and configured (for example, zones have been given runtimes) for the
programs. If you do not want certain programs to run, you can disable them. You can re-enable a
disabled program as needed.
1. Press the Program Setup button. The Program Setup menu displays.
2. If the program that you want to modify displays in the upper-left corner of the screen,
continue to step 3. Otherwise, press the PRG button until the program that you want to
modify displays in the upper-left corner of the screen.
Note: To move backwards in the list of programs, press and hold the PRG button, and then
press the – button repeatedly.
3. Press the  or  button to highlight the Enabled/Disable option, and then press the OK
button. The Enabled/Disable screen displays.
Page 49