Baseline Systems BaseStation 1000 - Manual (Page 60)

BaseStation 1000 Irrigation Controller Manual
 Event Switch Stop – If you have an event switch installed, you can use this stop
condition to have a program stop running when a specified switch condition occurs.
a. Notice that the serial number for one of your event switches is highlighted in the
Event Switch field. If this is the serial number for the event switch installed in the
area that this program will water, no change is required. If you need to assign a
different event switch to the program, press the + or – button to select a different
serial number.
b. Press the  button to highlight the Trigger field, and then press the + or – button
to alternate between “When Open” and “When Closed” to indicate which switch
condition will cause your program to stop.
Example: You have a rain switch that uses hydroscopic discs to detect rain and halt
watering. In this example, you would set the program stop condition for the switch
to “When Open.”
c. Press the  button to highlight the Stop field, and then press the + or – button to
alternate between “At End of Cycle” and “Immediately.” Select one of the options
to indicate when the switch condition will cause your program to stop.
 Temperature Stop – If you have an air temperature sensor installed, you can use this
stop condition to have a program stop running when a specified temperature is
reached.
a. Notice that the serial number for one of your air temperature sensors is
highlighted in the Temp. Sensor field. If this is the serial number for the air
temperature sensor installed in the area that this program will water, no change is
required. If you need to assign a different air temperature sensor to the program,
press the + or – button to select a different serial number.
b. Press the  button to highlight value in the Limit field, and then press the + or –
button to change the value in degrees Fahrenheit.
c. Press the  button to highlight one of the following stop options, and then press
the OK button:
o
Less Than Limit – Select this option if you want the program to stop
when the air temperature is less than the Limit.
o
Greater Than Limit – Select this option if you want the program to stop
when the air temperature is greater than the Limit.
d. Press the  button to highlight the Stop field, and then press the + or – button to
alternate between “At End of Cycle” and “Immediately.” Select one of the options
to indicate when the temperature condition will cause your program to stop.
Page 54