Baseline Systems BaseStation 1000 - Manual (Page 99)

BaseStation 1000 Irrigation Controller Manual
Enabling Start, Pause, and Stop Messages
The controller can display a message when a program starts, stops, or pauses. You can enable or
disable these messages at your discretion. By default, the messages are disabled.
To display a message when a program starts
1. Press the Program Setup button. The Program Setup menu displays.
2. If the program that you want to enable the message for displays in the upper-left corner of
the screen, continue to step 3. Otherwise, press the PRG button until the program that you
want to enable the message for displays in the upper-left corner of the screen.
Note: To move backwards in the list of programs, press and hold the PRG button, and then
press the – button repeatedly.
3. Press the  button to highlight the Setup Prg. Start option, and then press the OK button.
The Setup Prg. Start screen displays the list of start conditions.
Note: For information about configuring the fields on the Setup Prg. Start screen, refer to
Setting a Start Condition for a Program on
page 40.
4. Press the  button to highlight the Display
Message option, and then press the + button
to display a checkmark in the field.
5. To view the message, perform the steps in
Viewing Operator Messages on page 92.
To display a message when a program pauses
1. Press the Program Setup button. The Program Setup menu displays.
2. If the program that you want to enable the message for displays in the upper-left corner of
the screen, continue to step 3. Otherwise, press the PRG button until the program that you
want to enable the message for displays in the upper-left corner of the screen.
Note: To move backwards in the list of programs, press and hold the PRG button, and then
press the – button repeatedly.
3. Press the  button to highlight the Setup Prg. Pause option, and then press the OK button.
The Setup Prg. Pause screen displays.
Note: For information about configuring the fields on the Setup Prg. Pause screen, refer to
Setting a Pause Condition for a Program on
page 50.
4. Press the  button to highlight the Display
Message option, and then press the + button
to display a checkmark in the field.
5. To view the message, perform the steps in
Viewing Operator Messages on page 92.
Page 93