Baseline Systems BaseStation 1000 - Manual (Page 62)

BaseStation 1000 Irrigation Controller Manual
 If multiple water sources are available on the Water Source screen, you can perform the
previous procedure to disable WS-1 for a specific program and then associate a different
water source with that program. Make sure that the correct program displays in the
upper-left corner of the screen. Press the  button to highlight an unassigned water
source, and then press the + or – button to add a checkmark in the WS field.
 If multiple water sources are available on the Water Source screen, you can associate
more than one water source with a program. Make sure that the correct program
displays in the upper-left corner of the screen. Press the  button to highlight an
unassigned water source, and then press the + or – button to add a checkmark in the
WS field.
Setting Up a Rain Delay
When rain is expected, you can set up a rain delay that will prevent the controller from watering
while the delay is active. The rain delay stops all programs and sets the status of all watering events
to “Done.”
1. Press the RUN button.
2. Press the BACK button. The Status Report menu displays.
3. Press the  or  button to highlight Rain
Delay, and then press the OK button. The
Rain Delay screen displays. When no rain
delay is set, the Days to Delay field displays
Off.
4. Press the + or – button to set the number in
the Days to Delay field for the number of
days that you want the system to stop
watering.
Note: In the controller, 1 day is from the time you set up the rain delay until midnight on that
same day. The next day begins at 12:01am and ends at midnight.
5. When you have finished setting up the rain delay, press the RUN button. The Rain Delay
status displays in the upper-left corner of the screen.
Page 56