Baseline Systems BaseStation 1000 - Manual (Page 93)

BaseStation 1000 Irrigation Controller Manual
3. Press the  button to highlight the Export Data option, and then press the OK button to
select it. The Export Data screen displays.
4. Press the  button to highlight the type of
data that you want to export, and then press
the OK button.
5. Unplug the USB drive from the USB port on
the controller. When you plug the USB drive
into a computer, you will find the exported
files on the USB drive in a folder labeled with
the controller’s serial number.
Adding Expansion Modules
If you purchase an expansion module for your controller, install the module onto the controller
board as directed in the installation guide. Use the following steps to verify that the controller
recognizes the module.
1. Press the System Setup button. The System
Setup menu displays.
2. Press the  button to highlight the Expansion
Modules option, and then press the OK
button to select it. The Expansion Modules
screen displays.
3. Verify that the controller finds the expansion
module as shown in this screen illustration.
Enabling or Disabling the Weekly Test All
By default, the controller is configured to run a weekly test on all solenoids starting at midnight on
Saturday. The test pauses all irrigation until it is complete. If this test interferes with your watering
schedule, you can disable the test.
1. Press the System Setup button. The System
Setup menu displays.
2. Press the  button to highlight the System
Settings option, and then press the OK
button to select it. The System Settings
screen displays.
3. Perform one of the following actions in the
Do Weekly Test All field:
 Disable the test: If the weekly test is currently enabled, a checkmark displays in the Do
Weekly Test All field. Press the + or – button to remove the checkmark.
 Enable the test: If the weekly test is currently disabled, there is no checkmark in the Do
Weekly Test All field. Press the + or – button to replace the checkmark.
Page 87