Baseline Systems BaseStation 1000 - Manual (Page 85)

BaseStation 1000 Irrigation Controller Manual
The final step is to connect the controller to BaseManager by performing the steps below.
1. Make sure that the controller is connected to the network. Refer to Viewing the Ethernet
Information Screen on page 74. If the controller is not connected, perform one of the
following procedures:
 Enable the DHCP connection by performing the steps in Setting Up the Default Network
Connection on page 73.
 Connect the controller with a static IP address by performing the steps in Setting Up a
Static IP Address on page 73.
2. Make sure that you have performed the steps in Enabling the BaseManager Connection on
page 75 and that your BaseManager connection is “enabled.”
3. Press the System Setup button. The System Setup menu displays.
4. Press the  button to highlight the Network
Setup option, and then press the OK button
to select it. The Network Setup menu
displays.
5. Press the  button to highlight the
BaseManager Info option, and then press the
OK button to select it. The BaseManager Info
screen displays.
6. To connect to BaseManager, press the OK button. The Status field shows that the controller is
connected.
Note: When your controller connects to the
BaseManager server, the server detects the
connection and checks for an associated
account. If no account is found, the server
sends an authorization/registration PIN to
your controller. You might see the PIN
displayed on the controller’s main screen as
illustrated here, but you can also find the PIN
on the BaseManager Info screen. You will use
the PIN to create your BaseManager account.
Viewing BaseManager Information
1. Press the System Setup button. The System Setup menu displays.
2. Press the  button to highlight the Network Setup option, and then press the OK button to
select it. The Network Setup menu displays.
3. Press the  button to highlight the BaseManager Info option, and then press the OK button
to select it. The BaseManager Info screen displays.
4. Review the following information:
 Status – Indicates whether the controller is connected to BaseManager
Page 79