Baseline Systems BaseStation 1000 - Manual (Page 66)

BaseStation 1000 Irrigation Controller Manual
5. The Limit Zones by Flow option should be highlighted. If it is not highlighted, press the  or
 button to highlight it, and then press the OK button. The Limit Zones by Flow screen
displays.
6. In the Target Flow field, the gallons per
minute (gpm) value is highlighted. Press the +
or – button to change the number in the field.
 To change the value of the digits to the
right of the decimal, press the  button
to highlight those digits, and then press
the + or – button to change the number.
Note: Press and hold the + button or the – button to rapidly increase or decrease the number
in the field.
7. Press the  button to highlight the Limit Concurrent field, and then press the + or – button to
display a checkmark in the field. The checkmark indicates that the system will limit the
number of zones that can run at the same time by the gallons per minute in the Target Flow
field.
Setting a High Flow Limit for a Water Source
You can enter a high flow limit for a running water source and then set up the system to shut down
the water source if that limit is exceeded. The system uses this gallons per minute (gpm) value as a
critical limit. When this value is greater than zero, the system compares the limit against the
measured reading from the flow device every minute. If the flow rate reading exceeds the limit for
three or four minutes in a row, the system generates an alert. If you enable the Shut Down field,
then programs using this water source will be stopped and corresponding master valves (MVs) will
be shut off when the flow rate exceeds the limit.
1. Press the Flow Setup button. The Flow Setup menu displays.
2. The Water Source Setup option should be highlighted. If it is not highlighted, press the  or
 button to highlight it, and then press the OK button. The Water Source Setup screen
displays.
3. Press the  button to highlight the water source that you want to set the flow limit for, and
then press the OK button. The Flow Setup menu for that water source displays.
4. Press the  or  button to highlight the Flow Management option, and then press the OK
button. The Flow Management menu displays.
5. Press the  button to highlight the High Flow Limit option, and then press the OK button. The
High Flow Limit screen displays.
Page 60