Baseline Systems BaseStation 1000 - Manual (Page 39)

BaseStation 1000 Irrigation Controller Manual
8. Press the OK button. The serial number of the device that you selected in the Action column
now displays next to the number in the Event Switch column.
Note: If the search found multiple devices, the next serial number in the Action column is
automatically selected. Press the  or  button in the Event Switch column to move to the
next number that you want to assign, and then press the OK button.
9. Continue until you have assigned all your switch devices to their numbers.
Setting Up Event Switches
After you assign a device to a specific use in the BaseStation 1000 system, the device is
automatically enabled. You can disable that device if you want to take it out of service temporarily,
and then you can enable it again when necessary.
1. Press the Search & Assign button. The Search & Assign menu displays.
2. Press the  or  button to highlight the Event Switch option, and then press the OK button
to select it. The Event Switch screen displays.
3. Press the  or  button to highlight the Device Setup option, and then press the OK button.
The E. Switch Device Setup screen displays.
4. Press the  or  button to highlight the switch device number in the left column, and then
press the  button to move to the Enabled field.
 If the device is currently enabled, a checkmark displays in the Enabled field. Press the +
or – button to remove the checkmark.
 If the device is currently disabled, there is no checkmark in the Enabled field. Press the
+ or – button to replace the checkmark.
5. Continue until you have configured the settings for all your event switch devices.
Searching For and Assigning Air Temperature Sensors
1. Press the Search & Assign button. The Search & Assign menu displays.
2. Press the  or  button to highlight the Temperature Sensor option, and then press the OK
button to select it. The Temperature Sensor screen displays.
3. If the Device Assignment option is highlighted, press the OK button to select it. If Device
Assignment is not highlighted, press the  or  button to highlight it, and then press the OK
button. The Temp. Assignment screen displays.
4. When the Search option in the Action column is highlighted, press the OK button to search
for air temperature sensors.
When the controller finds the devices, their serial numbers display in the Action column.
5. Press the  or  button to move through the list of devices in the Action column. Highlight
the serial number of the air temperature sensor that you want to assign.
6. Press the  button to move to the Temp. Sensor column.
Page 33