Setting up the default network connection, Setting up a static ip address – Baseline Systems BaseStation 1000 User Manual

Page 79

Advertising

BaseStation 1000 Irrigation Controller Manual

Setting Up the Default Network Connection

The BaseStation 1000 is equipped for Internet-based LiveView™ which makes your controller

accessible anytime from anywhere, with any Internet-accessible device. The first step for enabling

Internet-based LiveView is to connect your controller to the Internet through your network. The

controller uses the Dynamic Host Configuration Protocol (DHCP) to have the IP address

automatically set by the network.

Note: The next step for enabling Internet-based LiveView is connecting to a BaseManager server.

Refer to Connecting to BaseManager on page 78 and Viewing BaseManager Info on page 79.

1. Plug an Ethernet cable into the Ethernet port on the back of the controller board and plug the

other end of the cable into a live Ethernet jack.

2. On the controller, press the System Setup button. The System Setup menu displays.

3. Press the  button to highlight the Network Setup option, and then press the OK button to

select it. The Network Setup menu displays.

4. The Ethernet Setup option should be highlighted. If it is not highlighted, press the  or 

button to highlight it, and then press the OK button. The Ethernet Setup screen displays.

5. Press the + or – button to change the value in the DHCP Enabled field. The controller uses the

Dynamic Host Configuration Protocol (DHCP) to establish the network connection.



If DHCP is currently enabled, a checkmark displays in the Enabled field. Press the + or –

button to remove the checkmark.



If DHCP is currently disabled, there is no checkmark in the Enabled field. Press the + or –

button to replace the checkmark. Refer to Setting Up a Static IP Address on page 73.

Note: To see the how the DHCP protocol automatically configured the network settings,

review the Network Info screen.

6. Continue to the Enabling the BaseManager Connection procedure on page 75.

Setting Up a Static IP Address

DHCP (Dynamic Host Configuration Protocol) allows your controller to automatically obtain an IP

address, which enables the connection to the Internet. Every time you restart your controller, it

retrieves a new IP address. DHCP is the default network configuration for the BaseStation 1000.

In some cases, private network configurations or network security issues might require that you

configure a static IP address for your controller.