Baseline Systems BaseStation 1000 - Manual (Page 97)

BaseStation 1000 Irrigation Controller Manual
Soaking A zone associated with this program has watered and is now
soaking
Paused A pause condition is in effect for this program
Disabled The program is marked as being disabled
Message There is a message associated with this program
Viewing the Flow and Master Valve/Pump Status Report
1. Press the RUN button.
2. Press the BACK button. The Status Report menu displays.
3. Press the  or  button to highlight Flow &
MV/Pump Status, and then press the OK
button. The Flow Status and MV/Pump Status
screen displays.
Icons representing the MVs and pump start
devices are listed at the top of the screen.
One water source is identified below with the
flow rate readings in gallons per minute
(GPM).
4. To view the report for the next water source, press the  button.
5. To return to the Status Report menu, press the BACK button.
Understanding MV/Pump Statuses
The following icons identify the status of the master valves and pump start devices:
Icon Status Description
Unassigned The MV/pump does not have a biCoder assigned to it
Idle (Done) The complete cycle has finished for this MV/pump – including
watering and soaking
Watering Watering is in progress
Disabled The MV/pump is marked as being disabled
Message There is a message associated with this MV/pump
Page 91