Baseline Systems BaseStation 1000 - Manual (Page 61)

BaseStation 1000 Irrigation Controller Manual
Setting Up a Master Valve/Pump Start for a Program
Use this option to associate a master valve or pump start biCoder with a program. Before you
perform this procedure, you must assign a biCoder as a master valve or pump biCoder. Refer to
Searching for and Assigning Master Valve and Pump Start biCoders on page 28.
1. Press the Program Setup button. The Program Setup menu displays.
2. If the program that you want to modify displays in the upper-left corner of the screen,
continue to step 3. Otherwise, press the PRG button until the program that you want to
modify displays in the upper-left corner of the screen.
Note: To move backwards in the list of programs, press and hold the PRG button, and then
press the – button repeatedly.
3. Press the  button to highlight the MV/Pump option, and then press the OK button. The
MV/Pump screen displays. The serial numbers of the biCoders that you assigned as master
valve or pump start biCoders display on the left side of the screen.
4. Press the  or  button to move to the serial number of the master valve or pump start
biCoder that you want to associate with this program, and then press the + or – button to
select that serial number. A checkmark displays on the right side of the screen.
Setting Up a Water Source for a Program
The BaseStation 1000 can manage 1 complete water source (master valve, flow sensor, and pump
start) and can be upgraded to support up to 3 water sources.
If your controller has been upgraded to support multiple water sources, you can associate a specific
water source with a specific program or associate multiple water sources with one program.
1. Press the Program Setup button. The Program Setup menu displays.
2. If the program that you want to modify displays in the upper-left corner of the screen,
continue to step 3. Otherwise, press the PRG button until the program that you want to
modify displays in the upper-left corner of the screen.
Note: To move backwards in the list of programs, press and hold the PRG button, and then
press the – button repeatedly.
3. Press the  button to highlight the Water Source option, and then press the OK button. The
Water Source screen displays. The available water sources are listed. By default, water source
1 (WS-1) is enabled for all programs.
4. Perform one of the following:
 If you want to disable WS-1 for a specific program, press the PRG button until the
program that you want to modify displays in the upper-left corner of the screen, and
then press the + or – button to remove the checkmark from the WS-1 field.
Page 55