Batch configuration, Figure 6-33 – Dell Emulex Family of Adapters User Manual
Page 1462
Boot for the Fibre Channel Protocol User Manual
P010096-01A Rev. A
6. EFIBoot
Save and Restore Configurations
1462
Batch Configuration
Batch configuration migrates an adapter’s configuration across several adapters at the
same time.
Note: No other adapter functions can be performed while batch configuration is in
progress.
There are two ways to perform batch configuration:
1. Migrate the configuration of one adapter to other adapters in the system.
2. Migrate the configuration stored in a previously saved configuration file to the
adapters in the system. This allows configurations to be migrated across systems.
To migrate the configuration of one adapter to other adapters in the system:
1. On the Save Configuration menu, select 2. Batch Configure Adapters. You are
prompted to select a source for the configuration (Figure 6-33).
Figure 6-33 Select Source for Adapter Configuration Data Menu