Dell Emulex Family of Adapters - Manual (Page 365)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
Dump Commands
365
Example
To enable dynamic target mode:
hbacmd SetDriverParam 10:00:00:00:c9:ff:ff:ff L P enable-dtm 1
To disable dynamic target mode, set the flag to 0.
SetDriverParamDefaults
This command changes all values to the default for the adapter(s).
Supported By
Linux, VMware ESXi, and Windows
Syntax
SetDriverParamDefaults <WWPN> <Flag1> <Flag2>
Parameters
Dump Commands
The diagnostic dump feature enables you to create a “dump” file for a selected adapter.
Dump files contain information such as firmware version, driver version, and
operating system information. This information is useful when troubleshooting an
adapter, but is unavailable in read-only mode.
Caution: Disruption of service can occur if a diagnostic dump is run during I/O
activity.
The dump files created are text files (“.txt” extension) and binary files. The extension
for binary files depends on the adapter type:

OneConnect and LPe16202 adapters (Enhanced FAT Dump) – “.edf” extension

OneConnect adapters (Core Dump) – “.core” extension

LPe16000-series adapters (except LPe160202) – “.bin” extension

LPe12000 and LPe11000-series adapters – “.dmp” extension
WWPN
The WWPN of an FC or FCoE port.
Flag1
L = Make change local for this adapter only.
G = Make change global (applies to all adapters on this host).
Flag2
P = Make change permanent (the change persists across reboot).
T = Make change temporary.