Dell Emulex Family of Adapters - Manual (Page 984)

Installation Instructions for DKMS Drivers 984
P007419-01B Rev. A
Installation Instructions for DKMS Drivers
DKMS-enabled drivers are provided for supported Linux RHEL 5 and SLES 10 distributions.
To install these drivers, do the following:
1. Set up the DKMS environment on the target system.
2. Install the DKMS drivers using the standard Linux RPM installation command, rpm -ivh.
To update the DKMS drivers, use the standard Linux RPM update command, rpm -Uvh.
For specific instructions on setting up the DKMS environment and using the rpm- commands,
see the Linux operating system documentation.
Copyright © 2011-2013 Emulex. All rights reserved worldwide. This document refers to various companies and products by their trade names. In most,
if not all cases, their respective companies claim these designations as trademarks or registered trademarks. This information is provided for reference
only. Although this information is believed to be accurate and reliable at the time of publication, Emulex assumes no responsibility for errors or
omissions. Emulex reserves the right to make changes or corrections without notice. This report is the property of Emulex and may not be duplicated
without permission from the Company.
Note: References to OCe11100 series products also apply to OCe11100R series products.
System: Linux RHEL 5 and SLES 10 distributions
Date: November 2013