Dell Emulex Family of Adapters - Manual (Page 567)

Emulex Drivers for Windows User Manual P010077-01A Rev. A
2. Installation
AutoPilot Installer
567
Option 1: Automatically Run the AutoPilot Installer
Use this option unless you have specific configuration needs.
1. Double-click the driver kit or run it from a command line. See appendix D.,
“AutoPilot Installer Command Line and Configuration File Parameters,” on
page 726 for information on the command line options. The command line
parameter APargs allows you to specify arguments that are automatically passed to
the AutoPilot Installer command. A Welcome page is displayed with driver kit
version information and Emulex contact information.
2. Click Next to proceed to the Installation Options page.
For each installation option, the default installation location for that option is
displayed. Browse to a different location, if desired.
3. Click Install to continue the installation.
The Progress dialog box is displayed. After all tasks are completed, the Finish
dialog box is displayed. The Start AutoPilot Installer box is automatically selected.
4. Click Finish. AutoPilot Installer runs automatically and completes one of the
following installations:

Hardware-First Installation or Driver and Utility Update (page 568).

Software-First Installation (page 569).
Option 2: Run the AutoPilot Installer Separately
To access these options, run AutoPilot Installer after the driver kit loading has been
completed. This allows you to change the configuration options supplied to the
AutoPilot Installer (see below).
1. Perform steps 1 through 3 for “Option 1: Automatically Run the AutoPilot
Installer”.
2. Clear the Run AutoPilot Installer check box on the Finish dialog box.
3. Click Finish. The driver kit installer exits.
After the driver kit loading is complete, change the configuration in one of two ways:

Change the configuration file. See “Software Configuration Parameters” on
page 728 for details.

Supply parameters on the command line. See appendix D., “AutoPilot Installer
Command Line and Configuration File Parameters,” on page 726 for details.
Once you have finished this step, you can run AutoPilot Installer at a later time, using
either of the following methods:
Note: If you are supplying options using the command line, you must run AutoPilot
Installer from the command line.

Select Programs>Emulex>AutoPilot Installer in the Start menu.

Run AutoPilot Installer from the command line. Type
C:\Program Files\Emulex\AutoPilot Installer\<driver type>\APInstall.exe