Dell Emulex Family of Adapters - Manual (Page 1679)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
12. Configuring UEFI for iSCSI
Adding and Configuring Targets
1679
Figure 12-14 Discovered Targets Screen
16. After you have added your targets, from the Controller Configuration menu, select
iSCSI Target Configuration and press <Enter> to view the added target
information.
Note: If you set the Boot Target option in step 5 before adding the target, the Boot
Target displays No on this menu. To enable Boot Target, proceed to step 17.
17. To enable Boot Target or make any other changes to your target or targets, select the
target and press <Enter>. The Edit/Ping iSCSI Target menu is displayed. From this
menu, you can edit your target.
Manually Adding, Discovering, and Managing Boot Targets
To manually add and discover boot targets:
1. On the Controller Properties screen (Figure 12-5), set Discover Boot Target via
DHCP to <Disable> and press <Enter>.
2. Select Save Changes and press <Enter>.
3. Reboot the system.