Dell Emulex Family of Adapters - Manual (Page 1581)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
6. Using the FCoE Boot BIOS Utility for x86 and x64 Architectures
Configuring Boot Devices
1581
Configuring Boot Devices
To configure boot devices:
1. On the main configuration menu (Figure 6-2), select Configure Boot Devices and
press <Enter>.
A list of eight boot devices is shown (Figure 6-5). Emulex recommends that you
configure only the bootable devices. The primary boot device is the first entry
shown. It is the first bootable device. If the first boot entry fails due to a hardware
error, the system boots from the second bootable entry. If the second boot entry
fails, the system boots from the third bootable entry and so on.
Note: This assumes the system BIOS supports BBS and the boot order is set using
the mapped drives.
Figure 6-5 List of Saved Boot Devices Screen
2. Select a boot entry and press <Enter>. A screen similar to Figure 6-6 is displayed.
Figure 6-6 Device Selection List Example Screen