Showtarget, Showtargetportal – Dell Emulex Family of Adapters User Manual
Page 391
OneCommand Manager Command Line Interface Version 10.2 User Manual
P010067-01A Rev. A
5. CLI Client Command Descriptions
iSCSI Commands
391
ShowTarget
This command shows the properties for a specified target. If you do not specify the
iSCSI target name <iscsi_target_name>, all targets and their associated properties
return. If you specify <refreshtargets> in place of the <iscsi_target_name>, all targets
are refreshed before returning the information. If you do not provide a
<iscsi_target_name> or <refreshtargets> value, only the targets from the last refresh are
displayed.
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
ShowTarget <MAC_Address> [<iscsi_target_name> | refreshtargets]
Note: Only one command option can be specified with this command. That is, you can
only specify either <iscsi_target_name> or <refreshtargets>.
Parameters
ShowTargetPortal
This command shows the properties for a specified SendTarget Portal. If the
<Target_IP> and <Port> are not specified, all SendTarget Portals and their associated
properties return.
Supported By
Linux, Solaris, and Windows
Syntax
ShowTargetPortal <MAC_Address> [<Target_IP> <Port>]
Parameters
MAC_Address
The MAC address of an iSCSI port.
iscsi_target_name
The target’s iSCSI name enclosed in quotes (string length:
11–255).
refreshtargets
Refresh all targets before displaying the information.
MAC_Address
The MAC address of an iSCSI port.
Target_IP
IP address of the target portal. You can specify an IPv4 or IPv6
Target IP address.
Port
Port number of the target portal.