Dell Emulex Family of Adapters - Manual (Page 1801)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
Appendix H. Configuring PXE Boot for NIC on Dell OCe14000-based Systems
PXE Boot Parameters Default Values
1801
Erasing Ports and Controller Configuration
Note: When selecting this setting, all previous configuration settings are returned to
their factory default settings including the current protocol selection. Emulex
recommends performing this action to provide a clean environment for new
configuration settings to take effect.
To erase the ports and controller configuration:
1. On the Controller Configuration screen (Figure H-2), press <F8> to restore the
factory default settings. A warning appears asking if you want to erase the current
configuration for all ports of the controller.
2. Press <Y> to delete the configuration. You will receive another warning asking you
to confirm the permanent removal of the controller configuration.
3. Press <Y> to delete the configuration.
To exit the PXESelect utility after erasing the ports and controller configuration:
1. Follow the instructions on the bottom of the individual menu screens until you are
prompted to exit.
2. Press <Y> to exit. Depending on what settings were changed, a reboot may be
necessary.
Note: For older systems, depending on the memory allocation method supported,
the PXESelect utility automatically reboots even when there are no changes
made to the system.
PXE Boot Parameters Default Values
The default settings for the PXE Boot parameters are listed in the following table.
Table H-1 PXE Boot Parameter Default Values
Parameter Default Value Valid Values
Hide Setup Prompt Disabled Enabled
Disabled
Banner Message
Timeout 8 0–14
Port Speed Auto Negotiated Auto Negotiated
10G
1G
PXE Boot Disabled
Note: On some Dell LOMs, this setting
is enabled by default on port 1.
Enabled
Disabled
Boot Retry Count 0 0 (no retry)
1–7 Retries