Dell Emulex Family of Adapters - Manual (Page 1789)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
Appendix G. Configuring PXE Boot for NIC on Dell OCe10100-based Systems
Setting Up a PXE Bootable Network
1789
2. The LEDs on your controller begin blinking. The selected port’s LED status
indicators blink on your controller until you select Done on this screen and press
<Enter>.
Note: Not all controllers have LEDs that are visible externally. If you are using an
add-in card in a blade server environment, the port identification or beaconing
capability does not work.
Erasing Ports and Controller Configuration
Note: When selecting this setting, all previous configuration settings are returned to
their factory default settings including the current protocol selection. Emulex
recommends performing this action to provide a clean environment for new
configuration settings to take effect.
To erase the ports and controller configuration:
1. On the configuration screen, select Erase Configuration and press <Enter>. A
warning appears asking if you want to erase the current configuration for all ports
of the controller.
2. Press <Y> to delete the configuration. You will receive another warning asking you
to confirm the permanent removal of the controller configuration.
3. Press <Y> to delete the configuration.
To exit the PXESelect utility after erasing the ports and controller configuration:
1. Follow the instructions on the bottom of the individual menu screens until you are
prompted to exit.
2. Press <Y> to exit. Depending on what settings were changed, a reboot may be
necessary.
Note: For older systems, depending on the memory allocation method supported,
the PXESelect utility automatically reboots even when there are no changes
made to the system.