Dell Emulex Family of Adapters - Manual (Page 378)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
iSCSI Commands
378
Parameters
DiscoveriSNSServer
This command discovers an iSNS server address through DHCP. If the DHCP server
returns an iSNS server address, it replaces the configured iSNS server and can be
viewed using the ShowiSNSServer command.
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
DiscoveriSNSServer <MAC_Address>
Parameters
ExportiSCSI
This command outputs iSCSI target information in XML format. The output can be
redirected to a specified file, and the file can be used for the ImportiSCSI command.
Supported By
Windows Only
Syntax
ExportiSCSI
Example
In this example, the command exports all the iSCSI targets of all the adapters on the
host. The output is re-directed to the file “targets.xml”.
hbacmd ExportiSCSI > targets.xml
GetInitiatorProperties
This command shows all the initiator login options for the specified port.
These properties are set as the target portal’s login properties to be used when
discovering the targets on the target portal. The discovered targets inherit these
properties.
MAC_Address
MAC address of an iSCSI port.
Dest_IP_Address
Destination IP address to delete from the route table.
Subnet_Mask
Subnet Mask to delete from the route table.
Gateway
Gateway to delete from the route table.
MAC_Address
The MAC address of an iSCSI port.