Dell Emulex Family of Adapters - Manual (Page 337)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
Authentication Commands
337
Parameters
GetAuthConfig
This command retrieves the authentication configuration for the adapter.
Supported By
Linux, Solaris, and Windows
Syntax
hbacmd GetAuthConfig <WWPN1> <WWPN2>
Parameters
GetAuthStatus
This command returns the current status for the authentication connection specified by
WWPN 1 and WWPN2 (adapter and the switch). It includes the current authentication
state (connected or failed). Currently authenticated connections specify the hash
algorithm and DH group used in the DHCHAP associated with this connection. Failed
status includes the failure reason.
Supported By
Linux, Solaris, and Windows
Syntax
GetAuthStatus <WWPN1> <WWPN2>
Parameters
WWPN1
The WWPN of an FC port.
WWPN2
Use “ff:ff:ff:ff:ff:ff:ff:ff” for a switch or use the WWPN for a target.
PasswordType
1 = ASCII
2 = Hex (binary)
3 = Password not yet defined
Password
The current password value.
WWPN1
The WWPN of an FC port.
WWPN2
Use “ff:ff:ff:ff:ff:ff:ff:ff” for a switch or use the WWPN for a target.
WWPN1
The WWPN of an FC port.
WWPN2
Use “ff:ff:ff:ff:ff:ff:ff:ff” for a switch or use the WWPN for a target.