Dell Emulex Family of Adapters - Manual (Page 1603)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
9. Configuring and Managing the iSCSI Initiator with the iSCSISelect Utility
Configuring Network Properties
1603
To enable MPIO support:
1. From the Controller Properties screen (Figure 9-4), select MPIO Port and press
<Enter>. A pop-up menu appears.
Figure 9-7 Controller Properties Screen with MPIO Port Pop-up Menu
2. Select Enabled or Disabled and press <Enter>.
3. To save your changes, select Save and press <Enter>.
Configuring Network Properties
The Network Configuration screen displays the MAC address, port speed, and link
status for the adapter. From the Network Configuration screen, you can configure the
following items:

IP version

VLAN ID/priority

IPv4 or IPv6 address
To view the network configuration:
1. From the Controller Configuration menu (Figure 9-3), select Network
Configuration and press <Enter>. The Network Configuration screen is displayed.
Figure 9-8 Network Configuration Screen