Rice Lake 880 Performance Series Indicator/Controller Technical/Service Manual - Manual (Page 19)

Installation 13
2.2.1 Mounting the Controller Assembly Remotely
To mount the controller assembly remotely a 6 pin connector (PN 153885) is required. See Figure 2-5 for terminal
location and pin assignments.
J1 J2 J3 J4 J5 J6
When mounting the display
remotely from the controller
assembly, connect to this
terminal. Pin Function
1 +6V
2 GND
3 -TX
4 +TX
5 -RX
6 +RX
Note
Controller Assembly can be mounted remotely on a standard 35 mm DIN rail up to 250 ft from display.
Figure 2-5. Mount Controller Assembly Remotely
Connector wire cage clamp 2Pos (J4, J5, J6),
insert all wires in the direction shown.
DTX+ DTX- DRX+ DRX- GND V_IN
J6 J5 J4
Display Board Assembly (PN 131598)
The connector on the display
b o a r d i s a c a g e c l a m p s t y l e ,
r e l e a s e b y p r e s s i n g o n t h e
connector tab.
Note
Figure 2-6. Wire connection to Display Board