Rice Lake 880 Performance Series Indicator/Controller Technical/Service Manual - Manual (Page 75)

Table 6-7. PORTS – Field Bus EDP Commands
Command Menu Description Choices / Range
FB.BYTESWAP#1 SWAP Specify byte swap for FB card NONE, BYTE, BOTH
FB.DEVICENETADDRESS#1 DVCNET Address for DeviceNet option 1-64
FB.PROFIBUSADDRESS#1 PRFBUS Address for Profibus option 1-126
EDP Commands 69
Ports – Field Bus Menu
Ports – Ethernet Menu
Command Menu Description Choices / Range
ETH.DEFAULTGATEWAY DFTGWY Default gateway valid IP address
ETH.DHCP DHCP Dynamic Host Configuration Protocal OFF, ON
ETH.DNSPRIMARY DNSPRI Primary DNS server address valid IP address
ETH.DNSSECONDARY DNSSEC Secondary DNS server address valid IP address
ETH.IPADDRESS IPADRS IP address for the indicator valid IP address
ETH.MACADDRESS MAC MAC address (read only) n/a – read only
ETH.NETMASK NETMSK Subnet mask valid IP address
ETH.CLIENT.ECHO CLIENT | ECHO Specifies whether characters received by the
port are echoed back to the sending unit. OFF, ON
ETH.CLIENT.EOLDLY CLIENT | EOLDLY Port end of line delay Range: 0 - 255
ETH.CLIENT.RESPONSE CLIENT | RESPNS Response – specifies whether the port
transmits replies to serial commands.
Parameter should be set to OFF to prevent a
reply from the indicator confusing an external
device (such as a printer) OFF, ON
ETH.CLIENT.REMOTESERVERIP CLIENT | RMOTIP Remote IP address of the remote machine that
the 880 will connect to valid IP address
ETH.CLIENT.REMOTESERVERPORT CLIENT | RMOTPT Remote port number of the remote machine
that the 880 will connect to Range: 1 - 65535
ETH.CLIENT.SFMT CLIENT | SFMT Stream format – specifies the stream format
used for streaming output of scale data
(TRIGGE=STRLFT or STRIND) Alphanumeric, max
Length: 200
ETH.CLIENT.TERMIN CLIENT | TERMIN Termination – selects the termination
character(s) for data sent from the port CR/LF, CR
ETH.CLIENT.TIMEOUT CLIENT | TIMOUT Inactivity disconnect timeout – connection is
dropped after a specified period (in seconds) of
inactivity. Setting the value to 0 disables the
parameter Range 0-65535
ETH.CLIENT.TRIGGER CLIENT | TRIGGE Selects the operation of the Client Ethernet
port COMAND, STRLFT,
STRIND
ETH.SERVER.ECHO SERVER | ECHO Specifies whether characters received by the
port are echoed back to the sending unit. OFF, ON
ETH.SERVER.EOLDLY SERVER | EOLDLY Port end of line delay Range: 0 - 255
ETH.SERVER.PORT SERVER | PORT Port that the 880 uses for its server Range: 1 - 65535
ETH.SERVER.RESPONSE SERVER | RESPNS Response – specifies whether the port
transmits replies to serial commands.
Parameter should be set to OFF to prevent a
reply from the indicator confusing an external
device (such as a printer) OFF, ON
ETH.SERVER.SFMT SERVER | SFMT Stream format – specifies the stream format
used for streaming output of scale data
(TRIGGE=STRLFT or STRIND) Alphanumeric, max
Length: 200
ETH.SERVER.TERMIN SERVER | TERMIN Termination – selects the termination
character(s) for data sent from the port CR/LF, CR
Table 6-8. PORTS – Ethernet EDP Commands