Rice Lake TransAct 5.0 - Installation & Operation Manual User Manual
Page 101
90
Reset
Reset the data terminal
Unattended
Put terminal in unattended mode
GetWeight
Get a weight from the unattended terminal
GetWeight
Get another weight
GetWeight
Get another weight
GetWeight
Get another weight
Attended
Put terminal in attended mode
Enable Repeater (Single Command)
When this box is checked, the command entered in the Data to Send box will be sent
repeatedly to the ATS-2.
Timer Interval (msec)
Enter the time interval between commands for the Loop and Repeater options.
Units
This field is not used.
Data Received
This field contains the message received from the ATS-2 in response to a command.
Data to Send
Enter a command to send to the ATS-2.
Attended
Place ATS-2 in attended mode
Unattended
Place ATS-2 in unattended mode
DriveAhead
Drive ahead command
DispMsgN
Display message on line N. This command is
immediately followed by the message to display.
Error
Error command
GetCode
Wait for and return driver entry
GetWeight
Get current weight
MoreMatrls
Ask driver if there is another material for this ticket
OpenGate
A valid truck id has been entered, open gate
PrintLine
Print ticket line
PrintEnd
Done printing ticket
Reset
Reset ATS-2