Rice Lake TransAct 5.0 - Installation & Operation Manual - Manual (Page 195)

184
FAQ
Okidata Printer Setup
Okidata ML 320 Turbo
How to tell if the Auto Tear-Off feature is turned on
1. Press the SEL button to turn the SEL light off.
2. Wait several seconds then press the SEL button to turn the SEL light back on.
3. If the paper moves to Top of Form, then back to the Tear-Off Position when the
SEL light is turned on, then Auto Tear-Off is turned on.
4. If the paper does not move when the SEL light is turned on, Auto Tear-Off is
turned off.
5. If you desire the Auto Tear-Off setting changed, please refer to the Okidata
User’s Guide for instructions or the following FAQ:
How do I enter the printer Menu to change settings on my Okidata ML320 Turbo printer?
Setting Top of Form with the Auto Tear-Off feature turned on
1. Press SEL to turn off the SEL light.
2. The paper should stay in the Tear-Off position. (If the paper is not in the tear off
position - Auto Tear-Off is not on. See the section for setting Top of Form with
Tear-Off turned off, or refer to the printer manual on how to turn on the Auto
Tear-Off feature)
3. Press TEAR button and hold it in. (The paper should move to the Top of Form.)
4. With another finger push the SHIFT button and hold it in.
5. Let go of the TEAR button and the paper should stay at the Top of Form as long
as the SHIFT button is held in.
6. Using the Micro Feed Up/Down buttons, adjust the paper to the desired Top of
Form position
7. When it is in the correct position, release the SHIFT button, the paper should
return to the Tear-Off position.
8. To check the Top of Form, press the TEAR button, the printer should go to the
Top of Form.
Setting the Tear-Off Position with Auto Tear-Off turned on
NOTE: Make sure the top plastic cover is in place before setting Auto Tear-Off. The
Printer will not adjust far enough down to tear off using the plastic paper guide just above
the print head.