8b 2.1, Powering on/off the balance and checking, Operation – Rice Lake TS Series, Rice Lake Weighing Systems - Operation Manual User Manual
Page 22: Reference
18 RL-TS Series Operation Manual
8B
2.1 Powering On/Off the Balance and Checking Operation
Turning the power of the balance on and off
1
Turn the power on.
Press the [On/Off] key.
Check that the AC adapter is connected. Zero is
shown in the display after all indicators light up.
2
Check operation.
Push the pan using your finger to check that the
display readout changes.
Also check that zero is given in the display after
the finger is released.
3
Turn the power off.
Press the [On/Off] key again.
The display lights out.
- The status of the balance obtained when the power is turned on is the
measuring mode that was used before the power was turned off. For
example, if the power is turned off in parts counting mode, the balance is
started up in parts counting mode when the power is turned on.
- When the balance is stable, “” is shown in the display.
If the balance is not stable, this “” lights out. The balance may be under
an external influence such as wind and vibration.
Changing settings by referring to “Section
5-6 Improving the Stability of
” (P.
) can improve stability.
- The bar graph is displayed in the display. This graph shows the current
weighted state as a ratio to the weighing capacity. The closer to the right
side of the bar, the closer the weight is to the weighing capacity.
Reference