Rice Lake TS Series, Rice Lake Weighing Systems - Operation Manual - Manual (Page 33)

RL-TS Series Operation Manual 29
45B
Setting a reference weight by entering a value
1
Set to the function setting mode.
(Refer to “Section 2-5: Function Setting Basics
(P.
X
22
X
).)
Press and hold the [Function] key. After “Func” is
displayed, release the finger.
2
Select “Percentage Weighing.” Press the [Zero/Tare] key several times to select “1.SEt
3 .”
3
Save the weighing mode. Press the [Target] key.
The “percent weighing” mode is set, displaying “%.”
4
Start setting the reference weight.
<Press and hold>
Press and hold the [Function] key. After “P SEt” is
displayed, release the finger.
The previously-saved reference sample weight blinks.
5
Enter a reference weight. Set the reference value with the following steps:
1. Press the [Zero/Tare] key.
The digit furthest to the right side of the value
blinks..
2. Select a number by pressing the [Zero/Tare] key.
Pressing the key toggles the number between 0 and
9, and decimal point.
3. Pressing the [Function] key selects the number and
the next digit blinks.
Set the reference weight by repeating steps 2 and 3.
Pressing the [Print] key can cancel the setting.
6
Save the value. Press the [Target] key to save the reference weight.